ENGLISH
BEFORE YOU OPERATE THE MONITOR 5
INSTALLATION OF TILT AND SWIVEL STAND
Install the stand on a stable surface. The monitor may cause injury or damage if it
falls or is dropped.
CAUTION
The monitor is designed to be used with the stand installed. Be sure to install the stand before
operating the monitor.
Do not give a strong impact to the monitor. It may cause damage.
n
Unplug the monitor before installation to avoid electric shock or damage.n
Ensure that the monitor is switched off.
A
C
Locate the cavities at the bottom front of the monitor.
Insert the pegs on the stand into these cavities. Push the stand forward until the stand locks
in place.
E
To remove the stand, hold the bottom of the stand, then push it out.
B
Carefully turn the monitor on its side or upside down.
D
n
To Next Page
Loading...
