ENGLISH
BEFORE YOU OPERATE THE MONITOR 7
Put the monitor on a stable surface. The monitor may cause injury or damage if it falls
or is dropped.
Do not give a strong impact to the monitor. It may cause damage.
Unplug the monitor before removal or installation to avoid electric shock or
damage.
CAUTION
<Installation>
Put a piece of soft cloth on the table beforehand to
prevent the monitor from being scratched. Lay the
monitor fl at on a table with front face down.
Hold the monitor and push the Stand until it clicks
and is secure.
Hold the monitor and push the Stand-Base until it
clicks and is secure.
Insert the Cable Holder into Hole.
<Removal>
Put a piece of soft cloth on the table beforehand to
prevent the monitor from being scratched. Lay the
monitor fl at on a table with front face down.
Press and hold the hooks inside, and pull the Stand-
Base.
There are two locks inside of the Stand, unlock
them by thin stick and pull the Stand away from the
monitor.
FITTING AND REMOVAL OF BASE : ProLite E2280HS
Stand-Base
Stand
Cable Holder
Hooks
Thin stick
To Next Page
Loading...
Need help?
General