ENGLISH
5 BEFORE YOU OPERATE THE MONITOR
Put the monitor on a stable surface. The monitor may cause injury or damage if it
falls or is dropped.
Do not give a strong impact to the monitor. It may cause damage.
Unplug the monitor before removal or installation to avoid electric shock or damage.
The monitor is supplied complete with a stand. If you prefer to wall mount the monitor, please follow
the instructions below to remove the stand. Be sure to include the stand with the monitor if it is
necessary to return the unit.
CAUTION
FITTING AND REMOVAL OF BASE
<Installation>
A
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor flat on a table with front face down.
B
The Stand-Bottom is pulled up as shown in the figure.
C
Install the Stand-Base to the Stand-Bottom.
<Remove>
A
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. Lay
the monitor flat on a table with front face down.
B
Hold down the hooks outside and pull the Stand-Base away from the Stand-Bottom.
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2410
To Next Page
Loading...
Need help?
General