ENGLISH
6 BEFORE YOU OPERATE THE MONITOR
Put the monitor on a stable surface. The monitor may cause injury or damage if it
falls or is dropped.
Do not give a strong impact to the monitor. It may cause damage.
Unplug the monitor before removal or installation to avoid electric shock or
damage.
CAUTION
FITTING AND REMOVAL OF BASE : ProLite B2280HS
<Installation>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Lay the monitor fl at on a table with front face down.
Install the Stand-Base to the Monitor.
Fix the Monitor to the Stand by the screw fi rmly and the push-down knob.
Place the Cable Holder.
<Remove>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Lay the monitor fl at on a table with front face down.
Pull up the knob, then remove the screws and the Stand-Base.
Push-down knob
Screw for Stand-Base fixing
Stand-Base
Cable-Holder
Stand-Base
To Next Page
Loading...
