ENGLISH
BEFORE YOU OPERATE THE MONITOR 9
Signal Timing
Change to the desired signal timing listed on page 26: COMPLIANT TIMING.
Windows 95/98/2000/Me/XP/Vista/7 Plug & Play
The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs on
Windows 95/98/2000/Me/XP/Vista/7 by connecting the monitor to DDC2B compliant computer with
the Signal Cable supplied.
For installation on Windows 95/98/2000/Me/XP: The monitor Information File for iiyama monitors
may be necessary for your computer and obtained via the Internet, using the address:
http://www.iiyama.com
For additional information on how to download the driver for your touch screen monitor,
please access the internet site noted above.
Monitor Drivers are not required in most cases for Macintosh or Unix operating systems.
For further information, please contact your computer dealer fi rst for advice.
COMPUTER SETTING
NOTE
ADJUSTING THE HEIGHT AND THE VIEWING ANGLE
For optimal viewing it is recommended to look at
the full face of the monitor.
Hold the stand so that the monitor does not topple
when you change the monitor’s angle.
You are able to adjust the monitor’s angle up to
21° upward, 4° downward.
In order to ensure a healthy and relaxed body
position when using the monitor at visual display
workstations, it is recommended that the adjusted
tilt angle should not exceed 10 degrees. Adjust
the monitor’s angle to your own preference.
Do not touch the LCD screen when you
change the height or the angle. It may
cause damage or break the LCD screen.
Careful attention is required not to catch
your fi ngers or hands when you change
the height or the angle.
NOTE
To Next Page
Loading...
Need help?
General