IK Multimedia Z-TONE Buffer Boost - Z-TONE Buffer Boost Specifications and Support; Audio and Power Technical Specs; Warranty and Support Information

To Next Page

To Previous Page

English

4 Specifications

Audio specs

I/O Gain: Unitary, from 1/4” input JACK to both 1/4” and XLR outputs when GAIN is at 0dB and Z-TONE at the

SHARP position.

Gain Range: From -8dB to +8dB

Boost Range: From 0dB to +10dB

Inputimpedance-Z-TONEsetonPASSIVEmode:Variablefrom1MΩdownto2.2kΩ

Inputimpedance-Z-TONEsetonACTIVEmode:Approx20kΩ

Outputimpedance,unbalancedout:56Ω

Outputimpedance,balancedout:600Ω

Max input level before clipping: +13dBm when powered by 48V phantom,+9dBm when powered by 9V battery

Dynamic Range: better than 114dB(A) for both outputs, input gain at 0dB

Total Harmonic Distortion, balanced output, 1kHz, +4dBm input: 0.0033% (PURE), 0.2% (JFET)

Total Harmonic Distortion, unbalanced output, 1kHz, +4dBm input: 0.00055% (PURE), 0.2% (JFET)

Frequency response: from 5Hz to 30kHz -1dB

Phase deviation: 0° +/-10° from 20Hz to 20kHz

Power

Phantom power: +48V phantom on Balanced output. +48V phantom has priority over installed battery.

Battery power: 9V

DC barrel: 9V DC (positive outside)

Current consumption from P48 phantom power source: 6.5mA

Warranty

For detail on your product’s warranty, please visit:

www.ikmultimedia.com/warranty

for the complete warranty policy.

Support and more info