Need help?Do you have a question about the IKA RW 20 digital and is the answer not in the manual?
General| Type | Overhead Stirrer |
|---|---|
| Speed Range | 60 - 2000 rpm |
| Mixing quantity max. (H2O) | 20 L |
| Viscosity max. | 10000 mPas |
| Motor rating input | 70 W |
| Motor rating output | 35 W |
| Speed display | Digital |
| Speed control | Stepless |
| Chuck range diameter | 0.5 - 10 mm |
| Extension arm diameter | 13 mm |
| Extension arm length | 160 mm |
| Permissible ambient temperature | 5 - 40 °C |
| Permissible relative humidity | 80 % |
| Protection class according to DIN EN 60529 | IP 20 |
| Voltage | 220 - 240 V |
| Frequency | 50/60 Hz |
| Power input | 72 W |
| Max. Torque | 150 Ncm |
Covers reading instructions, trained staff, hazard management, stand setup, and physical protection.
Details chuck safety, shaft protection, power procedures, speed limits, rotating parts, and emergency stop.
Specifies the intended use, suitable areas, and areas to avoid for the instrument.
Instructions for attaching the overhead stirrer to a stand using cross sleeve and extension arm.
Guidance on inserting and tightening the stirring tool into the chuck using the chuck key.
Recommended cleaning agents and precautions for the instrument.
Information on ordering spare parts and procedures for sending equipment for repair.
List of approved stirrer tools with their recommended maximum speeds.
To Next Page