iKarus C42B - Care and Maintenance

COMCO IKARUS
Maintenance Manual C42 Series
MaintenanceManual C42-
Series_Issue_VII_18.02.2014.doc
Revison No.:1 47 from 107
The following connections should be treated regularly:
− rod ends on the torsion tube under the control stick.
− rod ends on both elevator push-rods
− brass bushing in the torsion tube, directly under the control stick
− journal bearing in the elevator reversal bellcrank (Glykodur bushings)
− journal bearing of the aileron quadrant in the upper cockpit area (Glykodur
bushings)
− quick-releases of the aileron push-rods in the upper cockpit area
− journal bearing in the aileron bellcranks in the wing (Glykodur bushings)
− rod ends on the aileron push-rods (long, short)
− bolt connections of the short aileron push-rods at the ailerons
− journal bearing of the rudder pedals (Glykodur bushings)
− rod ends on the rudder push-rods to the nose wheel
− bearings of the pulleys for the aileron cables in the upper rear cockpit
− swivel bearings of the wing flap push-rods
− all cotter pin connections on all control surfaces as well as the trim tab
bolts
− all swivel bearings and bolt connections at the main landing gear.