WHEEL REPLACEMENT
Fit the wheel
Fit the spare tyre onto the hub, and
verify that the tting position is correct.
Screw and slightly tighten the bolts.
Loosen the jack to make wheel seat on
the ground, and take out the jack.
Tighten the wheel bolts with wheel
wrench diagonally.
Inate the wheel enough, and check
whether its pressure is the same with
that of the other wheels.
Put back the wheel
Remove the wheel central trim cover
from inside, and put the removed wheel
into the trunk spare wheel rack, tighten
the locking bolts of spare tyre.
Put back the wheel wrench and tool
spacer.
Steel rim spare tyre
If your vehicle is equipped with light
alloy wheel or steel rim spare tyre
and it is replaced with a steel rim one,
drive the vehicle with a speed not more
than 80km/h to the nearest Dongfeng
Franchise Store or IKCO authorized
representatives for repair, after the
wheel acceptable for normal running is
repaired properly, replace the spare tyre
immediately.
WARNING
When the vehicle is lifted by the jack
only, do not have any part of your body
stretched under the vehicle.
To Next Page
Loading...
Need help?
General
