IKEA FIXA - Work Area Safety; Electrical Safety; Personal Safety

paperclips,coins,keys,nails,screwsor
othersmallmetalobjectsthatcanmakea
connectionfromoneterminaltoanother.
Shorting the battery terminals together may
cause burns or a re.
Service
a. Haveyourpowertoolservicedbya
qualiedrepairpersonusingonlyidentical
replacementsparts.
This will ensure that the safety of the power tool
is maintained.
-This appliance is not intended for use by
persons (including children) with reduced
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instructions
concerning use of the appliance by a person
responsible for their safety.
-Children should be supervised to ensure that
they do not play with the appliance.
-Hold the machine by the insulated gripping
surfaces where the accessory may contact
hidden wiring or the mains cable. If the
accessory contacts a ‚live‘ wire, the exposed
metal parts of the machine can also become
‚live‘. Risk of electric shock.
Vibrationlevel
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories, may
signicantly increase the exposure level
- the times when the tool is switched off or when
it is running but not actually doing the job, may
signicantly reduce the exposure level
Protect yourself against the effects of vibration
by maintaining the tool and its accessories,
keeping your hands warm, and organizing your
work patterns.
Chargingyourdrill/driver
When the charger is connected to the electricity
supply, the red diode on the drill/driver lights
up. The diode lights up while the battery is
being charged (8).
Under normal conditions of use the screwdriver
can be recharged several hundred times.
ATTENTION! The recharging process generates
heat in the battery.
The battery that is supplied with the screwdriver
has been charged for test purposes only and
must be fully recharged before use. First read
the safety instructions and then follow the
loading instructions. Insert the charger plug into
the socket in the drill/driver. Then connect the
charger to the electricity supply.
Make sure that there are no knots or sharp
bends in the cable.
NEVER use this charger to recharge cordless
tools or batteries from other manufacturers.
Warning! Recharge the battery on a
non-ammable surface. Do not recharge the
battery for more than eight hours. The red diode
will extinguish when the battery has been fully
loaded.
Disconnect the cable and store the charger
in a suitable place when it is not in use. It
is not advisable to recharge the battery in
temperatures below freezing.
6 35