What does ER47 mean on my IKEA FORDELAKTIG Hob?
The ER47 error indicates an error in connecting the power cable on the product side. Disconnect the hob from the power supply and adjust the power supply connection according to the “ELECTRICAL CONNECTION“ paragraph, paying special attention to the correct fixation of the shunts on the product side.
Why is my IKEA FORDELAKTIG hood not working?
If the hood of your IKEA hob is not working, it might be due to a disconnected power cable. Reconnect the hood power cable, which is located towards the front right underneath the hob.
What to do if my IKEA FORDELAKTIG Hob is not working?
If your IKEA Hob isn't functioning, it might be due to a wrong connection to the mains or a short circuit. Disconnect the hob from the power supply and adjust the power supply connection according to the “ELECTRICAL CONNECTION“ paragraph.
What to do if IKEA Hob displays error E2?
If your IKEA hob displays error E2, allow the hob to cool down. Ensure you are using a suitable pan and avoid heating empty pans.
What to do if my IKEA Hob displays error ER21?
If the IKEA hob displays error code ER21, it indicates that the internal temperature of the electronic parts is too high. Let the hob cool down and ensure it has sufficient ventilation. If the error persists, further assistance may be needed.
What to do if my IKEA FORDELAKTIG displays error ER03?
If your IKEA hob displays the error code ER03, it means continuous key activation has been detected, possibly due to water or a pan on the control panel. Remove any water or the pan from the ceramic glass surface and control panel.
What to do if IKEA Ventilation Hood control panel turns off after 10 seconds but the extractor motor is still on?
If the IKEA Ventilation Hood control panel turns off after 10 seconds but the extractor motor remains on, it indicates continuous sensor activation, likely due to water or cookware on the glass over the control panel. Remove any water or cookware from the glass and control panel, then touch the control panel again.
How to fix an IKEA Ventilation Hood with no function?
If your IKEA Ventilation Hood has no function, it could be due to a wrong connection to the mains or a short circuit. Disconnect the hob extractor from the power supply. Adjust the power supply connection according to the electrical connection instructions. If the issue continues, please contact After Sales Service and specify the problem.
What does ER 03 and continuous tone mean on my IKEA Hob?
The ER 03 error with a continuous tone on your IKEA Hob indicates continuous sensor activation, likely caused by water or cookware on the glass over the control panel. Remove any water or cookware from the glass and control panel, and then turn off the hob.
How to fix acoustic signal upon ignition on IKEA Hob?
If you hear an acoustic signal upon ignition with no error code displayed on your IKEA hob, it may be due to a damaged or badly connected LIN cable to the hood electronic board. Check the connection. If the issue continues, further assistance may be needed.
Using the boost function for extra power for a maximum of 5 minutes.
Setting individual timers for cooking zones to automatically switch off.
Automatic hood operation linked to cooking zone power levels.
Table detailing user menu codes, descriptions, and configurable values.
Criteria for selecting suitable pots and pans for induction hobs.
List of error codes, possible causes, and solutions for appliance issues.
Troubleshooting steps for a non-functional fan, including cable checks.
Troubleshooting steps for a non-functional hood, including power cable checks.
Information on how to contact IKEA for support, installation, or function clarifications.
To Next Page
General