Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center.
Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent
person must do the troubleshooting that is
not in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem Possible cause Solution
The appliance is noisy. The appliance is not suppor-
ted properly.
Check if the appliance stands
stable (all the four feet should
be on the floor).
The compressor oper-
ates continually.
The Temperature regulator
may be set incorrectly.
Set a warmer temperature.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The door has been opened
too frequently.
Do not keep the door open
longer than necessary.
The product temperature is
too high.
Let the product temperature
decrease to room temperature
before storage.
The room temperature is too
high.
Decrease the room tempera-
ture.
The Fast freezing function is
switched on.
Refer to "Fast freezing func-
tion"
Water flows on the rear
plate of the freezer.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
This is correct.
Water flows on the
ground.
The melting water outlet does
not flow in the evaporative
tray above the compressor.
Attach the melting water outlet
to the evaporative tray.
There is too much frost
and ice.
Food products are not wrap-
ped properly.
Wrap the food products bet-
ter.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The Temperature regulator
may be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too high.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The product temperature is
too high.
Let the product temperature
decrease to room temperature
before storage.
ENGLISH 14
To Next Page
Loading...
