If the cabinet will be kept on, ask somebody
to check it once in a while to prevent the
food inside from spoiling in case of a power
failure.
What to do if…
Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent
person must do the troubleshooting that is
not in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem Possible cause Solution
The appliance is noisy. The appliance is not installed
properly.
Check if the appliance stands
stable (all the feet should be
on the floor).
The appliance does not
operate. The lamp does
not operate.
The appliance is switched off. Switch on the appliance.
The plug is not connected to
the mains socket correctly.
Connect the plug to the mains
socket correctly.
The appliance has no power.
There is no voltage in the
mains socket.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The lamp does not
work.
The lamp is defective. Refer to "Replacing the lamp".
The compressor oper-
ates continually.
The temperature is not set
correctly.
Set a higher temperature.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The door has been opened
too frequently.
Do not keep the door open
longer than necessary.
The food temperature is too
high.
Let the food temperature de-
crease to room temperature
before storage.
The room temperature is too
high.
Decrease the room tempera-
ture.
Water flows on the rear
plate of the refrigera-
tor.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
This is correct.
Water flows into the re-
frigerator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water
flows into the water collector.
Make sure that products do
not touch the rear plate.
ENGLISH 15
To Next Page
Loading...
