Counters k holes
Install the custom hardware handle(s) on the front of the wooden
panel inside dotted line.
IMPORTANT: If the handle is attached from the back of the
custom panel, the screw holes should be countersunk for the
screws heads to be flush with the panel. If the handle is attached
to the front of the custom panel, the screw lengths cannot exceed
the panel thickness.
Top of Psnel
Tapadelp_el
Dess_sdupannea_
centerl[ne
Lineacentral
Axe cenu_l
\\\
Using the template provided, attach it to the backside of the
custom panel with tape. Make sure that the center of the template
is aligned with the center of the wooden panel and top of the
template is aligned to the top face of the wooden panel.
iJ
NOTE: Do not drill deeper then %" (16 mm) to keep from drilling
through panel. Pilot hole depths given are for 3/4"(19 ram) thick
panel.
Mark 4 pilot holes on the wooden panel using the template
provided. Predrill 4 pilot holes using a 3/32"drill bit. Use tape to
mark the drill bit to gauge hole depth. Drill pilot holes
approximately %" (16 ram)into the custom panel.
5 Attach plastic studs
_P_ _ud-s-s_d
with 4 short screws
Visible side
Attach the 4 plastic studs to the wooden panel using the 4 short
#10 hex head (%6") screws provided.
assembly
Align the studs on the custom wood panel to the keyhole slots on
the door assembly. Ensure that all 4 plastic studs are engaged in
the keyhole slots. Slide wood panel down until the top surface of
the wooden panel is flush with the top of the door.
screws
Open the door and align top edges. Predrill 2 pilot holes using a
3/32"drill bit. Use tape to mark the drill bit to gauge hole depth. Drill
pilot holes approximately 11/2"(3.8 cm) into the top corners of the
door using hole in liner as a guide.
16
To Next Page
Loading...
