IKEA KYLIG - First Use; Daily Use

ENGLISH 8
Connect the appliance to the main power
supply.
The ideal temperatures for preserving food
have already been set at the factory.(MED)
Note: After switching the appliance on,
it will be necessary to wait for 4 to 6
hours before a temperature suitable for a
standard appliance load is reached.
Firstuse
Guidetoselectingfunctionstemperature
selection
Press the push button on the control panel
to adjust the temperature. Temperature
selection push button is used to set desired
temperature level, from warmest through
lower to coldest . Pressing push button
setpoint will change cyclically. Temperature
set-point is done for both compartments at
one time - fridge and freezer.
At rst plug-in of appliance factory set-point
is chosen - medium position.
Following table shows set-points level:
High temperature
Mid-high temperature
Middle temperature
Mid-low temperature
Low temperature
Legend:
Led OFF Led ON
FastCooling
The use of this function is recommended to
increase the cooling speed when placing a
very high quantity of food in the refrigerator
compartiment by pressing and holding
the push button on the control panel for 3
seconds.
Fast cool Fast cool
ON OFF
The Fast Cool light (yellow LED) will turn on.
The function is automatically deactivated
after 6 hours.
The Fast Cool function can be manually
deactivated by pressing and holding the
same push button on the control panel for 3
sec., the yellow LED is off.
Note: fast cool function should be also
switched ON before placing fresh food to be
frozen in the freezer compartment, in order
to maximize the freezing capacity.
Dailyuse
3”
C
A
Fast cool function indicator
B
Indication of temperature settings
C
Temperature selection /
Fast cool push button
D
Internal light switch
Controlpanel
DB
A