IKEA LUFTIG BF570 Guide

ENGLISH 8
WARNING:- Use safety gloves.
- Disconnect the appliance from the
power supply.
Perimetersuctionpanel
The suction panel must be cleaned with the
same frequency as the grease lter. Use a
damp cloth and a soft liquid detergent.
Do not use products containing abrasives.
DO NOT USE ALCOHOL
The panel normally covers the grease lters,
and must therefore be opened each time
access to the grease lters and the inside
of the hood is required (e.g. to replace the
carbon lters).
Opening: Pull the panel (LEFT SIDE)
downwards.
Closing: The panels must be xed to the
appropriate pins on the surface of the hood.
WARNING: Always check that the panel is
tted properly.
Tocleanthegreaselter
The lter traps all cooking grease particles.
The metal grease lter has unlimited
duration. It should be washed at least once
a month, either by hand, or by placing it in
the dishwasher (use a short cycle and low
temperature).
If washed in the dishwasher, the grease
lter surface may become matt. This will not
cause any reduction of performance.
To remove the lter pull out the handle.
After the lter has been washed and dried,
replace following the inverse procedure.
Replacingthehalogenlamps
WARNING:- Only use 12V 20W 30°
Ø35 12V GU4 halogen lamps.
1. Disconnect the hood from the electric
power supply.
2. Use a small screwdriver to remove the
lamp by pushing its edges upwards.
3. Remove the faulty light bulb and replace
with a new one.
Cleaningandmaintenance

IKEA LUFTIG BF570 Specifications

General

Brand	IKEA
Model	LUFTIG BF570
Category	Ventilation Hood
Language	English