IKEA MITTZON - Page 7

7
Collision detection
• The system is designed to avoid possible damages to equipment due to collision. When the desk detects a sudden change
in resistance, it will stop the movement and move in the reverse direction by approximately 30 mm-50 mm (depends on the
movement speed, collision force and the load during collision).
Reset Pin hole +Down
button
1 click the
pin-hole rst,
then long
press down
button
/ Orange
light
Steady
on
First, poke the pinhole at the bottom
of the hand controller with a pin
to enter the reset status (at this
time, the orange light will be steady
on), and then long press the down
button until the table goes down
to the lowest height, and then
raise it up 7 mm automatically to
complete the reset. After the reset is
successful, the orange light will turn
o.
Abnormal error
status
Pin hole +
Down button
Reset
operation
/ Orange
light
Blinks In the abnormal status, the orange
light continues to blink. Pressing any
button does not work. You need to
check if all the cables are properly
connected, and then perform the
reset.
Overheat
protection
status
/ Rest for
approx. 18
minutes
before
continuing
operation of
unit
/ Blue light Steady
on
This is not an abnormal error status,
but due to the motor working
continuously, overheat protection
may activate. After approx. 18
minutes of rest, the blue light will
turn o and normal operation can
be resumed.