ENGLISH 5
The manufacturer reects all
responsibilities for an damage caused
b improper use or rong settings.
Appropriate maintenance and cleaning
ensure the good orking order and
the best performance of the appliance.
egularl clean all stubborn surface dirt
to avoid grease build up. emove and
clean or change the lter regularl.
ever ame cook food ambé under
the appliance. sing free ames might
cause re.
ailure to observe the instructions for
cleaning the hood and replacing the
lters ma result in a re.
Ehaust air must not be vented through
a ue used for removal of fumes
produced b gas combustion appliances
or other combustible materials but must
have a separate outlet. All national
regulations governing etraction of
fumes must be observed.
There shall be adequate ventilation if
the hood is being used at the same time
as other appliances using gas or other
combustible materials. The negative
pressure of the room must not eceed
Pa bars. or this reason ensure
that the room is ell ventilated.
Do not leave fring pans unattended
hen fring as the fring oil ma catch
re.
Before touching the light bulbs ensure
that the are cold.
Do not use or leave the hood ithout
the light bulb correctl tted as this ma
cause electric shock.
The hood is not a ork surface therefore
do not place an obects on top of it or
overload it.
During all installation and maintenance
operations ear appropriate orking
gloves.
This appliance is not suitable for outdoor
use.
ARNING hen the hob is in use
accessible parts of the hood ma
become hot.
I
After unpacking the appliance check for
an transport damage. In the event of
problems contact the Authorized Service
Centre. To prevent an damage onl
remove the appliance from its polstrene
foam packaging at the time of installation.
ARNING this is a heav product the
hood should onl be lifted and
installed b to or more people.
The minimum distance beteen the hob and
the bottom part of the hood must not be less
than cm for burning gas or other fuels
and cm for electric cookers.
Before installation also check the minimum
distances stated in the manual of the cooker.
If the installation instructions for the cooker
specif a greater distance beteen cooker
and hood this distance must be observed.
E
ake sure the poer voltage specied on
the appliance rating plate is the same as
the mains voltage.
This information can be found on the inside
of the hood under the grease lter. Poer
cable replacement tpe must
be carried out b a qualied electrician.
Contact an authorized service centre.
If the hood is tted ith an electric plug
connect the plug to a socket compling ith
current regulations located in an accessible
place.
If no plug is tted direct iring to the
mains or if the socket is not located in an
accessible place a qualied electrician
should install a standardised double pole
poer sitch that ill enable complete
isolation from the mains in case of categor
III overvoltage conditions in accordance
ith iring rules.