Need help?Do you have a question about the IKEA RENLIG DWH B00W and is the answer not in the manual?
Ensure the appliance is disconnected from the mains before handling and installation.
Attach the provided mounting brackets to the appliance using the specified parts.
Measure the appliance width and calculate the required height adjustment for installation.
Attach the designated component to the appliance for installation purposes.
Use pliers to correctly attach the rollers or guides to the appliance.
Securely attach the specified components to the appliance body using the provided fittings.
Attach the final component to the appliance, ensuring proper alignment.
Two people are required to safely carry and position the appliance.
Insert the appliance into the cabinet and adjust its height using the leveling feet.
Use a wrench to ensure the appliance is perfectly level and stable.
Connect the water inlet hose to the tap, ensuring a secure and leak-free connection.
Details on water inlet tap sizes and the use of adapters for connection.
Connect the drain hose to the sink trap, ensuring it is properly secured and routed.
Securely fasten the drain hose connection to the sink trap using the provided clamp.
Place protective material on the floor under the appliance to prevent water damage.
Apply sealing tape to the edges of the cabinet and worktop to protect against humidity.
Carefully slide the appliance into its designated place within the cabinet.
Securely attach the top panel or worktop to the appliance and surrounding cabinets.
Attach the front door panel to the appliance, aligning it correctly.
Drill holes in the panel at the specified dimensions (700x600 mm) for mounting.
Fit the provided mounting brackets onto the prepared panel.
Attach the first part of the slide mechanism to the panel using screws.
Securely screw the slide mechanism part onto the panel.
Attach the additional bracket to the slide mechanism on the panel.
Finalize the attachment of the slide mechanism to the panel using screws.
Attach the remaining brackets to the panel for the slide mechanism.
Attach the slide mechanism components to the sides of the appliance.
Securely attach the slide mechanism to the appliance using the provided fittings.
Attach the final fixtures to the slide mechanism on the appliance.
Carefully insert the appliance with the attached slide mechanisms into the cabinet.
Secure the top panel or worktop to the appliance and surrounding cabinets.
Ensure proper clearances and prevent the appliance from contacting cabinet parts.
Secure the appliance to the surrounding cabinets using screws for stability.
Measure the required distance (605 mm) for the door panel alignment.
Cut or file the panel edge as needed for proper door fit and alignment.
Attach the decorative front panel to the appliance door.
Apply adhesive to the door and carefully fit the front panel.
Make final adjustments to the appliance's position and stability.
Do not use sealant on the appliance door or related components.
To Next Page
General
