6 AA-2289663-1
The lamps:
are they all in place, undamaged, properly screwed or
pushed in?
The plug/transformer
Check that the plug is not damaged.
Look for signs of overheating.
Check the fuse (if any), make sure it is the correct rating.
IF ANY DOUBT, HAVE THE SET CHECKED BY A QUALIFIED
ELECTRICIAN BEFORE USE OR SCRAP AND PURCHASE A
NEW SET.
Where the set is intended to be connected to the supply
via a 'plug-in transformer', only use the transformer
supplied with the set. Otherwise if the output voltage
does not match the voltage of the lamps overheating
may result.
Functional Tests
After the visual inspection and correcting any faults
found, including tightening of lamps and replacement
of broken or missing lamps, plug in and switch on the
lamp set. Replace any faulty lamps with ones of the
same voltage rating and manufacture, check the box for
details. Spare lamps are usually provided with the set.
Lamps should not be removed or installed with the
supply on.
Only replace 'fused' lamps (sometimes identied by a
white mark on the glass) with identical 'fused' lamps.
To Next Page
Loading...
Need help?
General
