IKEA STJARNSTATUS - Page 32

32
EN
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system. Systems certied for
cyst reduction may be used on disinfected
waters that may contain lterable cysts.
Test & certication results:
• Rated Capacity - 125 gallons/473
liters for the ice and water lter
• Rated service ow - .65 gallons per
minute
• Operating Temp: Min. 33°F, Max.
100°F
• Maximum Rated Pressure - 100
pounds per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your water lter:
It is not necessary to turn the water
supply off to change the lter. Be ready
to wipe up any small amounts of water
released during the lter replacement.
1 Turn Off the ice maker power switch.
2 Remove the old lter by rotating it
counter-clockwise (to the left) 90
degrees to release it.
3 Slide the old lter cartridge straight
out of the housing and discard it.
4 Unpackage the new lter cartridge.
Slide it into the lter housing as far as
it will go with the grip end horizontal.
5 Push lightly inward on the lter while
rotating it clockwise (to the right). The
lter will then pull itself inward as it is
rotated. Rotate the lter 90 degrees
until it stops and the grip end is
vertical. You may be able to feel a very
light click as the lter locks into place.
6 Press a drinking glass against the
water dispenser while checking for
any leaks at the lter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
The ice and water lter
system is tested and certied
to NSF/ANSI Standards 43,
53 and 401 for the reduction
of claims specied on the
performance data sheet.
More about your Advanced
Water Filter
FILTER REPLACEMENT
7 Continue dispensing water for 3-4
minutes or until 1.5 gallons of water
has owed through the system. You
will likely need to empty and rell
your glass several times.
8 Turn On the ice maker.
9 Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes
from Red to Green, the status has
been reset.