10
EN
DOOR REMOVAL
2 Disconnect the harness by grasping
both sides of the connector rmly,
depress the latch and pull apart.
Getting through narrow
spaces
If your refrigerator will not t through
an entrance area, you can remove the
doors. Check rst by measuring the
entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord
is unplugged from the wall outlet.
2 Open the freezer drawer and remove
the toe grille (see Installation
section).
3 Remove any food from the door
shelves and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each
cover over the top door hinges.
2 Lift inside edge of hinge cover and
tilt back.
Rear
Cover
Screw
Ground
Screw
Top
Hinge
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Front
Cover Screw
Water
Line
Rear
Cover
Screw
Top
Hinge
Ground
Screw
Cover Screw
Top Hinge
Cover
Hinge
Screws
Leave
Hinge
With
Door
To remove the refrigerator
doors
1 Remove top hinge covers. Trace
lightly around the door’s top
hinges with a pencil. This makes
reinstallation easier.
Note
DO NOT remove the ground screw
from hinge.
WARNING
Make sure the electrical power cord is
unplugged from the wall outlet.
To Next Page
Loading...
