IKEA STJARNSTATUS - Installation Procedures; Location Requirements

9
EN
Raise
To make nal door height adjustments:
Flipper
Mullion
Screw
Flipper
Mullion
Hinge
Adjusting Flipper Mullion Screw
2 Adjust ipper mullion height. For
proper connection with the ipper
mullion guide, there should be a
separation about the thickness of
a coin (0.060 inches, or 1.5 mm)
between the guide and ipper
mullion.
3 Re-tighten screw.
To adjust the ipper mullion:
1 Loosen the screw located on the
ipper mullion hinge.
Flipper
Mullion
Mullion
Guide
Thickness
of a Coin
Adjusting Flipper Mullion Height
INSTALLATION
1. Open freezer drawer to make lower
hinge visible.
2. Insert 6mm Allen wrench into the
shaft of the lower hinge.
3. Adjust the height by turning
clockwise or counterclockwise.
Turning clockwise will lower the door.
Turning counterclockwise will raise
the door. Default setting is to the
lowest height when you receive your
appliance.
Door
Door