IKEA STJARNSTATUS - Page 8

8
EN
INSTALLATION
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(2) Retaining Clips
3 Ensure both doors are bind-free with
their seals touching the cabinet on all
four sides and that cabinet is stable.
4 After unit is leveled, lower anti-tip
leg using a 3/8 inch socket wrench
until it rmly contacts the oor.
5 Install the toe grille by tting into
place.
Cabinet Leveling &
Refrigerator Door Alignment
(if necessary)
Guidelines for nal positioning of your
refrigerator:
• All four corners of the cabinet must
rest rmly on the oor.
• The front should be slightly elevated
to ensure that doors close and seal
properly.
• Doors should align with each other
and be level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front
rollers:
1 Slightly open freezer drawer if the
toe grill is installed. Lift the toe grille
and gently pull forward.
2 Make initial cabinet adjustments by
using the front roller height adjusting
screws. Use a 3/8 inch socket wrench
to turn the adjustment screws (1 per
side).
DO NOT
Loosen
or
Remove
These 3
Hex
Screws
Raise
Lower
Anti-tip
Leg
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
CAUTION
Do Not loosen or remove these 3 hex
screws.