6
English
ADD LIGHT SOURCES TO YOUR STEERING DEVICE:
Before you can use your light source you’ll need to pair
it with a steering device.
To add more light sources, just repeat the steps below:
1. Make sure that your light source is installed and the
main power switch is turned on.
2. Hold the steering device close to the light source you
want to add (no more than 5 cm away).
3. Press and hold the pairing button for at least
10 seconds. A red light will shine steadily on the
steering device. Your light source will begin to dim
and nally ash one time to indicate that it has been
successfully paired.
Up to 10 light sources can be paired with 1 steering
device.
Make sure to pair them one at a time. If the light
sources are close to each other, disconnect those that
have already been paired from the main power switch.
To Next Page
Loading...
