ENGLISH
6
ADD LIGHT SOURCES TO
YOUR STEERING DEVICE:
Before you can use your light
source you’ll need to pair it with
a steering device.
To add more light sources, just
repeat the steps below:
1. Make sure that your light
source is installed and the
main power switch is turned
on.
2. Hold the steering device close
to the light source you want
to add (no more than 5 cm
away).
3. Press and hold the pairing
button for at least 10
seconds. A red light will
shine steadily on the steering
device. Your light source will
begin to dim and nally ash
one time to indicate that it has
been successfully paired.
Up to 10 light sources can be
paired with 1 steering device.
Make sure to pair them one at
a time. If the light sources are
close to each other, disconnect
those that have already been
paired from the main power
switch.
To Next Page
Loading...
