IKEA TRETAKT - TRETAKT Product Information; Get to know your TRETAKT product; Factory reset your smart plug; Important Safety and Usage Notes

5
• Do not leave the Smart plug in direct
sunlight or near any heat source, as it
may overheat.
• Do not subject the Smart plug to wet,
moist or excessively dusty environments
as this may cause damage.
• The range between the steering device
and the receiver are measured in open
air. Dierent building materials and
placement of the units can aect the
wireless connectivity range.
WARNING:
• Do not connect after each other in
sequence.
• Do not cover when in use.
• To disconnect the power, pull the plug.
• Use only indoors in dry areas.
• Do not overload the product.
• Discard the product if damaged.
• For adult use only. This is not a toy and is
not intended for use by children.
product at a time. If your products are
close together, disconnect the ones you
have already connected while adding the
next product.
Get to know your TRETAKT product
• Press the On/O button on the smart
plug once to turn it on. Press it once
again to turn it o.
• When using a remote: Press the On
button (|)
to turn the smart plug on. Press the O
button (o) to turn the smart plug o.
Factory reset your smart plug:
Push the reset button on top of the smart
plug with a pointy object for at least 5
seconds until the LED starts pulsating.
IMPORTANT!
• The Smart plug is for indoor use only
and can be used in temperatures from
0ºC to 35ºC.