6
Factory reset
To reset and remove all connected
products, quick-press the pairing button 4
times (within 5 seconds). Follow steps 1-3
to reconnect your smart products.
IMPORTANT!
• The steering device is for indoor use
only and can be used in temperatures
ranging from
0º C to 40 ºC.
• Do not leave the steering device in direct
sunlight or near any heat source, as it
may overheat.
• Dierent building materials and
placement of the units can aect the
wireless connectivity range.
WARNING!
Risk of explosion if battery is replaced
by an incorrect type. Dispose of used
batteries according to the instructions.
Product servicing
Do not attempt to repair this product
yourself, as opening or removing covers
may expose you to dangerous voltage
points or other risks.
Get to know your RODRET product
Pairing button
Press to turn on, or long-press to
increase brightness
Press to turn o, or long-press to
decrease brightness
Changing the battery
A red LED light will blink when you press
any button the dimmer/power switch to
show that a new battery is needed. Open
the battery lid and replace with a new AAA/
HR03 battery. We recommend using a
LADDA rechargeable battery. Please note it
is sold separately.
To Next Page
Loading...