ENGLISH 6
III overvoltage conditions, in accordance
with wiring rules.
Use
The hood has been designed to be installed
and used either as a “Exhausted model”, or
as a “Recirculation model”.
Exhausted model (see symbol
in
installation booklet)
Cooking steam is sucked and channelled
outside the house through a discharge duct
(not supplied), tted to the hood steam
outlet.
Ensure that the discharge duct is correctly
tted to the air outlet, unit using an
appropriate connection system.
Important: If already installed, remove the
charcoal lter/s.
Where xing or mounting screws or other
xing devices are used, that penetrates into
the range hood with a accessible metallic
enclosure or class II construction, to attach
an accessory, the instructions shall indicate
the required location of these screws or
xing devices and include the substance of
the following warning.
Failure to install the screws or xing device
in accordance with these instructions may
results in electrical hazard.
Recirculation model (see symbol
in
installation booklet)
The air is ltered through one or more the
charcoal lters, and then resent into room.
Important: Ensure appropriate air
circulation around the hood.
Important: If the hood is supplied without
charcoal lters, these must be tted before
the hood can be used. Filters are available
in shops.
The hood should be installed away from
particularly dirty areas, windows, doors and
heat sources.
The accessories for wall xing are not
included because walls made of different
materials require different types of xing
accessories. Use xing systems suitable for
the walls of your home and the weight of
the appliance. For more details, contact a
specialized dealer.
Keep this booklet for future consultation.
To Next Page
Loading...
