ENGLISH 8
To clean the grease lter
The metal grease lter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with
a short cycle. With cleaning in a dishwasher
the grease lter may become dull; this does
not effect its ltering capacity.
Grease lter maintenance:
1. Disconnect the hood from the electric
power supply.
2 Remove the grease lters: pull the spring
release handle downwards, then remove
the lter.
3. After cleaning the grease lter, remount
in reverse order ensuring the entire
extraction surface is covered.
Charcoal lter maintenance (if the hood is
installed in recirculation mode)
1. Remove the grease lters.
2. Fit (bayonet attachment) 1 charcoal lter
each conveyour side.
3. Reverse the above procedure to remove
the charcoal lter.
4. Ret the grease lters,
Charcaol lter is neither lavable nor
regenerable.
Replace it every 4 months.
Lamp maintenance
Disconnect the hood from the electricity.
Warning
Prior to touching the light bulbs ensure they
are cooled down.
1. Use a small screwdriver or other suitable
tool to prise off the cover.
2. Snap-t the cover back on.
3. Use only max 12V-10W- G4 halogen
bulbs.
Important: make sure you don’t touch the
lamp with your bare hands.
To Next Page
Loading...
