Ikegami TM20-20RH - 5-5. Memory Storage and Change

5-5. Memory Storage and Change
(1) Changing PRESET Data
[Example 1] Changing Scrl'en NORMAL SCAN and UNDER SCAN
Order
Operation
1
2
3
4
5
6
7
8
- 28 -
Explanation
When adjusting from the normal scan
screen size, first press the jSCANI switch
to output the
"NORMAL SCAN" on
the screen.
Press the !CHANGE PRESET ! switch.
Each preset switch blinks.
However, the
jAPTj preset sv,itch does
not blink unless the front panel IAPTI
switch is "ON".
Preas the !WIDTH ! switch and change
the screen width with the rotary
encoder.
Pr ess the jIIEIGIIT! switch and change
the screen height
with the rotary
encoder.
Next you adjust the under scan screen
size, so press the jSCANI
sv.•itch to
output the "UNDER
SCAN" on the
screen.
Press the
IWIDTH i switch and change
the screen width with the rotary
encoder.
Press the
jHEIGHTj switch and change
the height of the screen with the rotary
encoder.
If you want to change the over scan
screen size, do so as in Steps
5-7.
When you have finished changin the
data, press the CHANGE PRESET
switch. The new data is stored into
memory when the LED goes out.
If you
press the !CLEAR!switch anytime before
you press the !CHANGE PRESET!
switch, this thr ows out the new data
and returns the system to the data you
had before you started the changes.
-·,.
r·l
:J
l
I
·:1
··.1
. /I
I
. l
•... J
_J
u
l ,j