Ikegami TM20-20RH - Removal of Cover; 7-1. How to Remove the Cover

l
.
. _~-
. . ,
:.:!
r ·
r;
··.;
!.
··.
t.
L
7. REMOVAL OF COVER
& WARNING
Do no1 open covers, except for serviceman.
It is very dangerous as
a high volt~ge exists inside.
7-1. How to Remove the Cover
The same procedure applies with the TM14-20RH / RP,
TM20-20RH/RP,
and TM20-30RH / RP models.
(1) Removing the Top Cover
Remove the four screws that hold on the top
cover of the monitor. (Refer to Flg. 7-1-1)
Cover remov al to this point is sufficient to
carry out the whit e
balnnce adjustm ent or the
focus adjustment opera tions (Section 5-4).
(2) Removing the Side Cover
Remove the four screws hold ing on the covers of the
left and right sides of the monitor. (Refer to Fig.
7-
1-2, Fig. 7- 1-3)
/ '
I
y- ·
4 screws
,-/~--
,,
Fig. 7-1-2. left Side Cover
In switching over the connector to stop
change s to the ROTATIO N, remove only th e
left side cover.
- 55 -
Rear
4 screws
,-/~-,
I I I
.__,
Front
Fig.
7-1-1 Top Cover
'
~, D
~
.,
I
4 screws
_/~ __
....
..._
Fig. 7-1-3. Right Side Cover
Wh en carrying out operat ions such as
mounting a board in the SLOT section, remove
only the right side cover.