Ikelite PCa - LED Light User Manual

Removable Battery Plate
The White Collar Lock Button must be
p
ushed “forward” and held to release
the Collar. Hold the body with one
hand while pushing the White Collar
Lock button forward with your finger.
Slide the Collar up about 1/4” to
its “open” position while holding the
Collar Lock Button forward.
The Collar Lock Button can now be
released and the front of lite can be
pulled from the body.
NNOOTTEE::
Lithium-ion batteries are not recommended. Use of
lithium-ion batteries can lead to shortened LED life or LED failure.
Lift out the removable top battery plate and load six “AA” size alkaline
batteries into the body. Note the polarity chart is engraved on top of the
removable plate. Install batteries into the light body and then place the
top plate back into the body.
The “O” ring must be clean and have a very light coating of
silicone lube on the surface. Push the front into the body,
hhoollddiinngg iitt
ttiigghhttllyy iinn ppllaaccee
while pushing the Collar Lock back to the closed position.
Check that the Collar Lock Button has clicked into place securely.
P
ush White Collar Lock
button forward
and hold
S
lide Collar Up 1/4”
to its Open Position
Pull front of Lite
from body
O RING
PPCCaa --
LLEEDD
LLiigghhtt
LLUUBBRRIICCAANNTT IISS PPAACCKKEEDD IINN
TTHHEE FFOOLLDD OOFF TTHHEE CCAARRTTOONN
The PCa-LED Light runs cool and can
be used for extended periods of time
above or under water.
IIkkeelliittee UUnnddeerrwwaatteerr SSyysstteemmss
50 W 33rd Street
Indianapolis, IN 46208
317-923-4523
Email - ikelite@ikelite.com
Web Site - www.ikelite.com
Collar
Collar Lock Button
Switch
Switch Lock
PCa_LED_Light_Inst:Layout 1 1/24/08 12:27 PM Page 1

Ikelite PCa - LED Light Specifications

General

Light Source	LED
Beam Angle	10 degrees
Burn Time	4 hours
Battery Life	Up to 4 hours
Material	Polycarbonate
Battery Type	4 x AA Alkaline
Depth Rating	100m (330 ft)

Summary

Ikelite PCa LED Light Operation

Light Disassembly

Instructions on how to release the collar lock and pull the front of the light from the body.

Battery Type Warning

Advises against using lithium-ion batteries to prevent shortened LED life or failure.

Installing and Specifications

Installing 6 - "AA" Batteries

Procedure for loading six alkaline "AA" batteries into the light body.

Collar and O-ring Care

Guidance on collar screw tightness, o-ring cleaning, and silicone lube application.

LED Lamp and Performance

Details on the non-replaceable LED, its lifespan, and continuous burn times.

Depth Rating and Warranty

Specifies the depth rating and outlines the limited lifetime warranty terms.