8
1. The wheel can be re-positioned and / or congured for left-hand use (see
page 21 in this manual for details).
2. Throttle Trigger: Controls forward / reverse / brake motion (designed to
be operated with index nger).
3. Hand Grip: For holding the transmitter.
4. Antenna: Transmits signal to the receiver located in the vehicle. Flip up
when the transmitter is in use. Fold for storage.
5. Power switch: Turns the transmitter ON / OFF.
6. Multifunction Red Indicator LED.
a. Power indicator.
b. Low battery voltage warning. When ashing batteries should be replaced /
recharged before continued use.
7. REV / Pair:
a. Use to reverse servo / channel operation.
b. Use to put the transmitter into pairing mode.
8. Digital Trim: All switches are digital so there’s no need to readjust the
trim position for different models after initial setup.
a. Steering: Controls the hands-off left / right direction of the vehicle.
b. Throttle: Adjusts the motor speed to STOP when the trigger is in the hands-off
(neutral) position.
9. Dual Rate Adjustment / Memory Reset: Adjusts total travel of servo in
both directions / Resets model memory or performs full TX factory reset
10. Battery compartment: Houses [4] AA batteries or a NiMH rechargeable
battery pack for powering the transmitter.
11. Channel 4 / Fail-safe: Toggle Channel 4 ON / OFF. Use to set the fail-safe
in case of signal loss.
12. Mode Switch:
a. Standard Mode: All functions are fully operational.
b. Feature Lock: Disables all buttons except steering trim.
c. Beginner Mode: Reduces throttle output to 50%.
13. Channel 3 adjustment knob.
14. LED Light ON / OFF: Use to switch the LED Light ON / OFF.
15. Roller button: Use to scroll through programming options and select an
item.
16. Back button: Use to backtrack through the programming menus.
17. LCD
To Next Page
Loading...
