Ikra ICPS 2020 - User Manual

Questions and Answers

M
matthewcampbellJul 30, 2025
Why are the chain and guide rail hot on my Ikra ICPS 2020 Pole Saw?
- T
  Tiffany SnyderJul 30, 2025
  If the chain or guide rail of your Ikra Pole Saw gets hot, it could be due to several reasons. First, check if there's enough oil in the tank and top it up if needed. A blocked vent in the oil tank cap can also cause this issue, so clean the cap. Additionally, ensure the oil outflow channel is clear. Finally, a blunt chain can lead to overheating, so resharpen or replace the chain.
C
camachodavidAug 6, 2025
What to do if Ikra ICPS 2020 Pole Saw does not pluck, vibrate, or saw properly?
- J
  Jesse MendezAug 6, 2025
  If your Ikra Pole Saw does not pluck, vibrate, or saw properly, it could be due to a few reasons. Check the chain tension and adjust if it's too loose. Also, a blunt or worn chain can cause this, so resharpen or replace the chain as needed. Finally, ensure the saw chain is fitted with the teeth pointing in the correct direction.
N
Nicholas StevensAug 14, 2025
How to fix a dry saw chain on an Ikra Pole Saw?
- Z
  zrobinsonAug 14, 2025
  If the saw chain on your Ikra Pole Saw is dry, it could be due to a few reasons. First, check if there is oil in the tank and top it up if needed. Also, the vent in the oil tank cap might be blocked, so try cleaning it. Finally, ensure that the oil outflow channel is not blocked and clear it if necessary.
T
twilliamsAug 22, 2025
What to do if Ikra Pole Saw is working erratically?
- M
  morriserikaAug 22, 2025
  If your Ikra Pole Saw is working erratically, it could be due to a loose internal contact. It is recommended to visit a specialist workshop.