iLive ITP231B - Clock, Alarm, and Sleep Timer; Setting the Clock and Alarm; Setting the Sleep Timer; Audio Inputs and Subwoofer Output

Customer Support: 1-888-999-4215 iLive 9
Clock, Alarm, and Sleep Timer
1. Press the POWER button to turn the power o.
2. Press the CLOCK button on the remote control.
3. The time on the display will begin blinking.
4. Press the REV/MIN and FWD/HR buttons on the
remote to adjust the minute and hour.
5. Wait 5 seconds to nish setting the clock.
1. Press the POWER button to turn the power on.
2. Press the SOURCE button on the bar speaker to
switch to the desired sleep timer source.
3. Press the SLEEP button repeatedly to set the
sleep timer.
4. After the set sleep time has expired, the bar
speaker will automatically power o.
1. Press the POWER button to turn the power on.
2. Adjust the volume to the desired level.
3. Press the POWER button to turn the power o.
4. Press the ALARM button on the remote control.
5. The alarm time on the display will begin blinking.
6. Press the REV/MIN and FWD/HR buttons on the
remote to adjust the minute and hour.
7. Press the SOURCE button on the bar speaker to
switch to the desired alarm source.
8. Wait 5 seconds to nish setting the alarm.
9. ALARM will appear on the display when the
alarm is set.
10. Press the ALARM button to cancel the alarm.
Setting the Clock
Setting the Sleep Timer
Setting the Alarm
Audio Inputs and Subwoofer Output
1. Connect a 3.5mm Audio Input cable (not
included) to the 3.5MM AUDIO INPUT on the
bar speaker and an audio source.
2. Press the POWER button to turn the bar speaker
on.
3. Press the SOURCE button to switch to LINE
mode.
4. Use the native controls on the connected audio
device to begin playing music through the
connected bar speaker.
1. Use an RCA cable (included) to connect an
external subwoofer to the SUBWOOFER
OUTPUT.
2. When audio is played through any source, the
bar speaker will automatically use the connected
subwoofer.
1. Connect an RCA cable (included) to the
AUXILIARY INPUTS on the bar speaker and an
audio source.
2. Press the POWER button to turn the bar speaker
on.
3. Press the SOURCE button to switch to AV mode.
4. Use the native controls on the connected audio
device to begin playing music through the
connected bar speaker.
Using the 3.5mm Audio Input Using the Subwoofer Output
Using the RCA Audio Input