IMade3D JellyBOX - User Manual

To Next Page

In this guide, we attach Left filament fan to the X carriage.

_________________________________________________________________

Left Filament Fan

You'll need:

Green left filament fan shroud

Pink left filament fan mount

Plastite screw (5)

30mm fan

Alert: If you're building Dual Fan JellyBOX, use the 30mm fan with a long wire.

Connect the green filament fan shroud and the pink shroud mount with a single

plastite screw.

#prep X Assembly 02: Left Fan

Page 1

Need help?

Do you have a question about the IMade3D JellyBOX and is the answer not in the manual?

Summary

Details necessary components: green shroud, pink mount, screws, and a 30mm fan, with a special note for dual fan setups.

Connects the 30mm fan to the shroud using four plastite screws, ensuring correct wire orientation for proper function.

Assembles the fan unit to the X carriage using provided bolts and washers, ensuring secure attachment.

Places the fan's wire into the designated slot along the bottom of the X carriage for neat routing.

Inserts and secures an M3 nut into the X carriage slot to prepare for, and then fasten, the fan assembly.

General