boiling water
Use a pot large enough to fit all parts without touching the sides.
If the pot is too small, the parts may become damaged or warp.
Once the water reaches boiling point, turn off the heat and then submerge parts in boiling water.
Stir occasionally to avoid allowing imani parts to touch each other or the sides of the pot for
an extended period of time. Remove parts after 3-5 minutes.
Prior to first use, please sterilize all parts except the main pump body in boiling water.
Once the water reaches boiling point, turn off the heat and then submerge accessories in
boiling water. Remove accessories after 3-5 minutes.
Do not boil any parts for more than 5 minutes,
as extended exposure to heat may damage them.
Not suitable for microwave or steam sterilization methods.
Be aware that some steam and microwave sterilizers
reach high temperatures which may risk
warping plastic parts.
Caution ! Follow correct sterilization method
※How to pour milk into a bottle
Turn the cap clockwise a lot when charging.
Please close the cap when using.
Pouring milk without removing the Main Body first, creates a risk of backflow.
Place the Cup on a flat, firm surface and open the cap carefully to prevent breast milk in the cup
from spilling.Use your thumb to squeeze the Breast Shield and slowly angle the Cup to gently pour the
milk in the bottle.
You can change the time for automatic turn off.
1. Press the power button.
2. Press +, - buttons about 5 seconds at the same time.
Change the time with +, - buttons
(Change the time from 10 to 40 minutes with 5 minutes at a time)
3. Press the power button to save.
※ Open the cap.
Correct
position
of cap
Quick manual
imani i2 Plus only
MASSAGE B. PUMP
This Product turns off after 20 minutes automatically.
To Next Page
Loading...