What to do if my Imetec B28 100 does not produce steam?
If your Imetec Styling Iron isn't producing steam, there are a couple of things to check. First, make sure the reservoir is filled with water. If it is empty, fill it. Then, activate the steam function by fully pressing the heating plates down about five times. Also, ensure that the reservoir is correctly attached to the base. If it's not, set it properly in place.
Why is my Imetec B28 100 leaking water from the reservoir?
If your Imetec Styling Iron's reservoir is leaking water, it could be due to the rubber cap not being closed properly. Ensure that the rubber cap is carefully closed. If the rubber cap is torn, you will need to go to an authorised assistance centre.
Procedure for filling the water reservoir for steam function.
Instructions for turning the appliance on/off and setting temperature.
Information about the automatic shut-off feature after 60 minutes.
Guidance on preparing hair and the appliance's operating states.
Step-by-step instructions for straightening hair with steam.
How to lock and unlock the heating plates of the appliance.
Details on how to obtain service and support for the appliance.
General| Type | Straightening Iron |
|---|---|
| Temperature (max) | 230°C |
| Warm-up time | 30 seconds |
| Voltage | 220-240V |
| Frequency | 50-60Hz |
| Plate Material | Ceramic |
| Plate Width | 25mm |
| Temperature Settings | Adjustable |
| Auto Shut-off | Yes |
| Weight | 0.3 kg |
| Cord Length | 2 meters |
To Next Page
