1. LCD display
1.1 Date and time
1.2 Systolic blood pressure
1.3 Diastolic blood pressure
1.4 Heart beat frequency
1.5 Irregular heart beat indicator
1.6 Flat battery indicator
1.7 Memory position
1.8 Unstable or excessive cuff pressure indicator
1.9 Inflation error indicator
2. Classification of the pressure values based on WHO
indications
3. Risk indicator
4. "START" button
5. "MEM" Memory button
6. Cuff
7. Tube for connecting the cuff to the appliance
8. Connector for connecting the tube to the appliance
9. Battery compartment
INTENDED USE
The automatic blood pressure measuring system is specific for
measuring blood pressure and heart beat frequency in adults.
TECHNICAL ALARM
The display shows the 'Hi' or 'Lo' technical alarm if the blood
pressure measured (systolic or diastolic) is beyond the blood
pressure measurement range specified in the SPECIFICATIONS
section. In this case, repeat the measurement and if the condition
persists, consult a doctor. The 'Hi' or 'Lo' technical alarm is pre-set
during production and cannot be adjusted or disabled by the user.
This alarm condition is assigned with low priority according to IEC
standard 60601-1-8. The technical alarm is not stored and does
not need to be reset.
EN
7
To Next Page
Loading...