Why does my Imetec Succovivo Pro 2000 stop during extraction?
Your Imetec Juicer may stop during extraction because the motor cut out switch has tripped due to overheating. Press the On/Off button to REV and resume the process. If the appliance does not resume operation, let it cool down for 10 minutes before re-using it.
How to clean stains on Imetec Succovivo Pro 2000 Juicer plastic parts?
To clean stains caused by vegetables like carrots on the plastic parts of your Imetec Juicer, use a cloth dipped in vegetable oil.
Why is my Imetec Succovivo Pro 2000 Juicer leaking juice?
If juice leaks out of the juicing container of your Imetec Juicer, make sure that you properly close the silicone lever at the bottom of the container.
What to do if there is too much pulp in my Imetec Succovivo Pro 2000 Juicer filters?
If excessive pulp accumulates in the filters of your Imetec Juicer, remove the filter and reamer. Clean them to remove the pulp between individual batches of juice, and then resume the process.
What to do if food is not extracted in Imetec Juicer?
If the food continues to turn in the filters and is not extracted by your Imetec Juicer, operate it in REV mode a couple of times.
General introduction to the appliance and important notes for understanding the manual.
Key safety warnings, including cautions before initial use and general handling advice.
Crucial safety warnings and precautions during appliance operation.
To Next Page
General