PEARL SERIES Operation Manual Page 79
Pioneer in Digital Vision Technology
0xF2F1011C
Power on default memory channel
Bit 0 ~ Bit 3 : power on initial memory channel
Read/Write
0xF2F10200
Camera version register
Bit 16~Bit 31 : camera version
(ex: If reading value: 0x00003000, camera version is 3.000)
Read only
0xF2F10120
Bright Level for Iris Control Application
Bit 24 ~ Bit 31 : Bright Level for Image Capture
Read only
0xF2F10124
Test Pattern
Bit 0 : Vertical Grey Bar
Bit 1: Bias Grey Bar
Read/Write
0xF2F10128
Defer Image control (Frame save)
Bit 0 : presence inquiry (read only)
Bit 6 : defer image On/Off control
( 1: image hold mode, 0 : normal real time mode)
Bit 7 : send image command :
If bit 6 is on status, this bit is send image command from camera to PC.
Bit 16 ~ Bit 23 : Queue size inquiry : Must check whenever format or mode is
changed (read only)
Bit 24 ~ Bit 31 : At read operation, this value is the number of remained
image at queue.
At write operation, this value is the number of sendin
es by bit 7 send
image command
Read/Write
0xF2F1012C
4 step knee LUT run control register
LUT knee 1st point register
Bit 0 : presence inquiry (read only)
Bit 1 : LUT regeneration command (self cleared)
Bit 2~Bit4 : reserved
Bit 5 : enable brightness, sharpness, gamma feature with knee function
Bit 6 : On/Off
Bit 7 : reserved
Bit 8~Bit 19 : X coordination of 1st knee point
Bit 20~Bit31 : Y coordination of 1st knee point
Read only
0xF2F10130
LUT knee 2nd point register
Bit 0 : presence inquiry (read only)
Bit 1 : LUT regeneration command (self cleared)
Bit 2~Bit5 : reserved
Bit 6 : reserved
Bit 7 : reserved
Bit 8~Bit 19 : X coordination of 2nd knee point
Bit 20~Bit31 : Y coordination of 2nd knee point
Read/Write
0xF2F10134
LUT knee 3rd point register
Bit 0 : presence inquiry (read only)
Bit 1 : LUT regeneration command (self cleared)
Bit 2~Bit5 : reserved
Bit 6 : reserved
Bit 7 : reserved
Bit 8~Bit 19 : X coordination of 3rd knee point
Bit 20~Bit31 : Y coordination of 3rd knee point
Read/Write
0xF2F10138
LUT knee 4th point register
Bit 0 : presence inquiry (read only)
Bit 1 : LUT regeneration command (self cleared)
Bit 2~Bit5 : reserved
Bit 6 : reserved
Bit 7 : reserved
Bit 8~Bit 19 : X coordination of 4th knee point
Read/Write
To Next Page
