imilab EC4 - Camera LED Status

14
Caomera LED Status
Status
Power On/Off
Press and hold the sync
button for 2 seconds until
the blue light becomes too
solid
You will hear the power-on
music
Press and hold the sync
button for 8 seconds until
the LED blinks red
You will hear the power-off
music
Camera Charging
Use USB to charge the
camera, red blinks three
times
Starts charging
Solid green
Fully charged
Camera Reset
Press and hold the sync
button for 5 seconds until
the LED blinks blue,
release the button
Reset successfully
Blinking blue
Reset Successfully
Solid blue (turn off after 5
seconds)
Pairing Successful
Blue and orange blinks 3
times alternately
Pairing Failed
PIR Detection sensitivity
adjustment
Orange blinks once
PIR detects motion
Orange blinks continuously
PIR continues to detect
motion