Immergas CAR V2 - Page 8

8
3) To make the electrical connections (Fig. 4) do not operate
when the boiler is live. e connection must be made
respecting the polarity of the wires (+ and -). e jumper
on clamps 40 and 41 of the boiler P.C.B. (if present) must
also be eliminated.
Connect the CAR
V2
remote control to the boiler clamps
envisioned at communication with the CAR remote
control or, if not present, to the clamps envisioned for
the CRD.
Note: refer to the electrical connections stated in the
boiler instruction book.
e connection to the boiler is made using two wires (Fig.
5) with minimum section of 0.50 mm
2
and maximum of
1.5 mm
2
and with maximum length of 50 metres.
N.B: for correct installation prepare a dedicated line for
the connection of the CAR
V2
remote control according
to the Standards in force regarding electrical systems.
If this is not possible interference due to other electric
cables could cause malfunctioning of the CAR
V2
remote
control itself.
4) Fix the body of the CAR
V2
remote control to the support
template, engaging it with pressure and using the two
screws provided (Fig. 3).
5) Insert 2 1.5 V AA batteries (not supplied) into the pre-set
housing (Fig. 1-8) and close the battery compartment.
6) Aer the boiler has been powered, wait about 30 seconds
before regulation in a way that the communication be-
tween CAR
V2
remote control and boiler has established.