Immergas MAGIS M4-30 - User Manual

Other manuals for Immergas MAGIS M4-30

Questions and Answers

R
Raymond MedinaAug 11, 2025
What to do if Immergas Water Pump is on but does not heat or cool as expected?
- X
  xgallegosAug 11, 2025
  If your Immergas Water Pump is running but not heating or cooling properly, there could be several reasons: * The temperature setting might be incorrect. Check the parameters T4HMAX, T4HMIN in heating mode, and T4CMAX, T4CMIN in cool mode, and T4DHWMAX, T4DHWMIN in DHW mode. * The water flow might be too low. Ensure all shut-off valves are correctly positioned, the water filter isn't clogged, there's no air in the system, the water pressure is above 1 bar (when cold), the expansion vessel isn't damaged, and the hydraulic circuit's pressure drops aren't too high for the pump. * The water volume in the system may be insufficient. Ensure it exceeds the minimum required value.
N
Nathaniel WilkinsonAug 22, 2025
Why does my Immergas Water Pump make noise (cavitation)?
- K
  Kathryn JohnsonAug 22, 2025
  If your Immergas Water Pump is making noise due to cavitation, it could be caused by: * Air in the system. You should purge the air. * Low water pressure entering the pump. Check that the water pressure is above 1 bar when cold and that the expansion vessel isn't damaged.
L
Laura WellsAug 31, 2025
What to do if the water pressure safety valve opens on my Immergas Water Pump?
- S
  stacy30Aug 31, 2025
  If the water pressure safety valve on your Immergas Water Pump opens, it could be due to: * A damaged expansion vessel. In this case, replace the expansion vessel. * The system's filling water pressure being higher than 0.3 MPa. Ensure the filling water pressure is approximately 0.10-0.20 MPa.