Need help?Do you have a question about the immerSUN M3P Series and is the answer not in the manual?
Explains the meaning of warning, mandatory, and informational symbols used in the manual and on the device.
Details recommended environmental conditions and placement requirements for the EV charging station.
Outlines essential safety measures and precautions for the installation process.
Covers critical safety guidelines and prohibitions for operating the EV charging station.
Specifies safety requirements and precautions for maintenance personnel.
Describes the charging mode, specifically Mode 3 as per IEC 61851-1.
Details the different charging connection cases (Case B and Case C) according to IEC 61851-1.
Describes the Type 2 charging connector and its specifications as per IEC 62196-2.
Introduces the AC EV charging station and its general application.
Explains the structure and meaning of the model numbers for the charging station.
Lists detailed technical specifications including electrical, ambient, and mechanical parameters.
Details the process of unpacking the charging station and inspecting its contents and condition.
Outlines necessary preparations and considerations before proceeding with the installation.
Provides a sequential guide with instructions for installing the charging station on the wall.
Describes how to install the empty socket for protecting the charging connector when not in use.
Instructions on how to switch on the power supply and the initial state of the station.
Introduces the user interface elements including LEDs, card swipe area, and control buttons.
Guides users on how to configure the charging station's parameters via WiFi.
Explains how to initiate the charging process using different control modes.
Details the procedures for normally stopping the charging process.
Describes scenarios and causes for abnormal charging stops.
Provides a guide to diagnosing and resolving faults based on LED indicators and fault codes.
Outlines recommended maintenance schedule and checks for ensuring long-term operation.
General| Product Type | Battery Charger |
|---|---|
| Series | M3P |
| Input Voltage | 230V AC |
| Battery Type | Lead-acid, Lithium-ion |
| Communication | CAN Bus |
| Charging Stages | Bulk, Absorption, Float |
| Protection Features | Over-voltage, Over-current, Short circuit, Reverse polarity, Over-temperature |
| Operating Temperature | -20°C to 50°C |
To Next Page