How to Unfold your Immotor GO
from Stand-By to Power Assist
Stand-By Power Assist
1
2
STEP 1
3
1) Insert finger below the latch to the back of the slot, then
lift to pop “T” handle up.
2) While holding “T” handle, lift and release trigger latch in order
to push rear wheels backwards until they lock into place, forming
a triangle base as shown above.
3) Press red button located under the “T” handle with thumb and
pull “T” handle up to extend. Raise handle bars.
*Tutorial videos are available on the App and at www.immotor.com
To Next Page
Loading...