December, 2014 IMPCO Technologies Inc. PPI-131 REV. A
3030 South Susan St. Page 1 of 16
Santa Ana, CA 92704
www.impcotechnologies.com
3030 S Susan Street, Santa Ana, CA 92704
Ph: +1 714 656 1200 Fax: +1 714 656 1400
Genius Max
REGULATOR REPAIR KIT INSTRUCTIONS
NOTE: Only die cast Genius Max
regulators manufactured late 2014 and
after can be repaired using the repair kits
listed below. Repairable units are
identified by the IMPCO logo and the
words Genius Max cast into the top
cover. All Genius Max regulators black
in color are not serviceable using these
repair kits.
Important: Any maintenance, service or
repair should be performed by trained and
experienced service technicians. Proper
tools and equipment should be used to
prevent injury to the servicing technician,
property or system components. Service
repairs should always be performed in a
safe environment and the technician should
always wear protective clothing to prevent
injury.
The IMPCO PPI-131 repair kit instructions
will provide the technician information to
successfully repair the Genius Max
regulator. Always inspect the major casting
pieces for damage, corrosion or cracks
before attempting a service repair. Be sure
the repair kit part number you are using is
correct for the regulator being serviced.
Prior to disassembly, inspect the body for
any signs of impact, cracks or other damage
to the body that might render the regulator
non-repairable.
Do not use Teflon tape to seal any fuel fittings.
Failure to follow this warning may cause the
regulator to leak internally, that may cause serious
injury and/or property damage.
Genius Max Regulator Repair Kit Part Numbers
Repair Kit, Genius Max (Includes the Pressure Relief Device or valve)
To Next Page
Need help?
General
