English 3
SAVE THESE
INSTRUCTIONS
FOR HOUSEHOLD
USE ONLY
HOW TO USE
• Make sure plug fits tightly into outlet. 120
volts 60 hertz,
A.C. current. A loose fit will
cause overheating and permanent damage
to the plug.
• Turn fan switch to desired level: Low,
Medium or High.
•
To turn off fan, use the switch and turn to
Off.
•
Always operate fan on its base in the nor-
mal position with both legs on the floo
r.
CARE & CLEANING
• This fan should be cleaned on an as needed
basis to prevent restricted air flow of both
grilles and moto
r.
• Before cleaning the fan, unplug the power
cord from outlet.
• Remove front grille by removing screws
on the sides (
DO NOT REMOVE REAR
GRILLE).
• Clean grilles and blade with damp cloth.
Avoid harsh chemical cleaners as these amy
ruin the fan finish.
• Do not immerse the motor in water.
• Re-attach front grille.
• Remove excess dust from the motor vents
with a vacuum cleane
r.
•
Your fan motor is permanently lubricated
and requires no additional oil.
•
Allow fan to dry completely before use.
Tab
1.
2.
3.
4. Before each use, inspect the power cord
forcuts and/or abrasion marks. If any are
found, this indicates that the appliance should
be serviced and the power cord replaced.
Please return it to the manufacturer for service
or to an authorized service representative.
5. Never wrap the cord tightly around the
appliance as this could cause the appliance to
fray and break.
6. Do not replace attachement plug.
This
contains safety device (fuse) that should not
be removed, Discard product if the attachment
plug is damaged.
IMPO
RTANT: During the first few minutes of
initial use, a slight odor may be noticeable. This
is normal and will quickly disappea
r.
CAUTION: Do not alter the fan
’s assembly.
HOW TO REPLACE FUSE
WARNING: Risk of fire. Do not replace
attachment plug. Contains a safety device (fuse)
that should not be removed. Discard product if
the attachment plug is damaged.
1. Open fuse cover - slide open fuse access cover
on top of attachment plug towards blade.
2. Remove fuse carefully - turn fuse holder over
to remove fuse.
3. Close fuse cover - slide close the fuse access
cover on top of attachment plug.
WARNING! Risk of fire. Replace fuse only
with2.5
Amp, 125 Volt fuse.
To Next Page
Loading...
