© RTO 2000
Page 13
INTRODUCTION
Congratulations on the purchase of this IMPULSE SD-1200 Amplifier. Rest
assured you have purchased a quality product designed and engineered to
give you many years of uncompromised musical service. This amplifier
has been designed using the latest in electronic technology available today
and will provide you with years and years of high quality sound level
amplification and reproduction.
This amplifier has been designed with a fully regulated 100% MOS-FET
Power supply assuring extremely quick switching response and self
protection with soft starting power turn on.
PROTECTION CIRCUITRY
Advanced protection circuits have been designed into all our amplifiers.
The protection circuits will disable the amplifiers if it senses an input
overload, speaker short circuit or extreme high temperature conditions.
When the protection circuit is in operation the amplifier will go into a self
preservation mode. At this time please check your system to see what is
causing the protection circuit to fire. The amplifier can be reset by turning
the remote power off and then on again. If the system shuts down because
of the thermal overload condition, allow the amplifier to cool down before
restarting. If the amplifier shuts down because of an input overload or
speaker short circuit please be sure to correct these conditions before
restarting the amplifier.
WE WANT YOU LISTENING FOR A LIFETIME
Used wisely, your new sound equipment will provide a lifetime of fun and
enjoyment. Since hearing damage from loud noise is often undetectable
until it is too late, we recommend you to avoid prolonged exposure to
excessive noise.
To Next Page
Loading...
Need help?
General
